Skip to main content
English (CA) Français (Canada)

Disassembly of a Bestar Wall Bed

  • Updated

Introduction

Disassembling a Bestar wall bed can be a detailed process, requiring careful attention to the specific design and components of Bestar products. This guide provides a comprehensive step-by-step process to safely and effectively disassemble a Bestar wall bed.

Tools Required

  • Screwdrivers (Phillips and flathead)
  • Adjustable wrench
  • Safety goggles
  • Work gloves

Safety Precautions

  1. Read the Bestar Manual: Always refer to the Bestar instructions before starting.
  2. Clear the Area: Ensure the area around the wall bed is clear of obstacles.
  3. Use Proper Tools: Use the recommended tools to avoid damage.
  4. Wear Safety Gear: Use safety goggles and work gloves to protect yourself from potential injuries.
  5. Have a Helper: Bestar wall beds can be heavy. It’s advisable to have someone assist you.
  6. Important Warnings:
    • Professional Assistance: Only a professional or qualified person should proceed with the disassembly, reinstallation, and any adjustments.
    • Bed Stability: The bed should remain anchored to the wall during the initial steps of disassembly to prevent tipping and injury.

BESTAR is released from any responsibility and will void the warranty if the disassembly is not performed according to the instructions in this manual. BESTAR and its distributors shall not be liable for any damages arising out of or in connection with improper anchoring of the bed or non-compliance with the anchoring procedure.

Qualified Person: Ensure the disassembly is done by someone with the necessary skills and knowledge, particularly understanding the wall anchors used during the original installation. Follow all applicable regulations in your province, state, or country.

Step-by-Step Disassembly Instructions

  1. Remove the Mattress

    • By removing the mattress, the bed frame will rise quickly. Have a helper hold the frame down while removing the mattress.

  2. Remove the Four Slats

    • Remove the four slats at the middle and foot end of the bed to gain access to the front facades/door panels.

  3. Unscrew the Facades

    • Unscrew the facades using screws VR-215.

  4. Rotate the Leg

    • Rotate the leg towards the interior.

  5. Keep the Bed in a Semi-Closed Position

    • Use an object of about 2 inches (50 mm) thick to keep the bed in a semi-closed position, then lift and pull to remove the facades.

  6. Remove the Stop Molding

    • Take off the stop molding by removing the 5 screws on top.

  7. Let the Bed Frame Sink Back

    • Let the bed frame sink back into the cabinet and remove the cylinders.
    • Unscrew the fastener and remove the end of the cylinder from the “L” bracket.

  8. Remove the Bearing Supports

    • Unscrew and remove the bearing supports KI-993-P.

  9. Lift the Metal Bed Frame

    • Lift the metal bed frame from the brackets and slide the frame forward.

  10. Unscrew the Bed from the Wall

    • Now you can unscrew the bed from the wall and continue the disassembly.

Conclusion

Disassembling a Bestar wall bed requires following the specific instructions provided by Bestar. By adhering to this step-by-step guide, you can safely and effectively disassemble your Bestar wall bed for moving, storage, or disposal. If you encounter any difficulties or uncertainties, consult the Bestar manual or seek professional assistance.

Keep this information for future reference.

Related to

Related articles